Insert Select

The Insert Select command inserts a parallel construct (also known as an OR construct) at the insertion point for an Activity diagram or an EFFBD. This command is available either from the Insert submenu of the right-click context menu or by dragging the Select construct from the Insert tab of the diagram Toolbox to the desired insertion point.

 

  

 

If you insert by using the ribbon commands, GENESYS will insert based upon your current selection. If a node or construct is selected, GENESYS will insert before the selected object. If a branch is selected, GENESYS will insert at the end of the branch. If nothing is selected, GENESYS will insert at the end of the main branch.

 

NOTE:

Within GENESYS, select constructs are equivalent to exclusive ORs. During execution, only one path is taken, not many.