ModelCenter MBSE  

The ModelCenter MBSE® Connector, that is included in the GENESYS Pro version, provides the ability to seamlessly export model segments from GENESYS projects into ModelCenter MBSE. After working with the model in ModelCenter MBSE, updated design value can then be imported back into the GENESYS model. The connector gives the engineer a variety of ways to export three interrelated GENESYS classes which correspond to the Ansys  model. Uses include:

 

• Verify constraint diagrams and definitions by executing them.
• Inform the systems model with the results of detailed design tools in order to do
• • Model verification
  • Design verification
  • Requirements compliance
• Test the model in a variety of simulated environments to do
• • Mission Analysis
  • Verify performance requirements at the systems level
• Mix and match different potential components to do
• • Trade studies
  • Cost tradeoff studies

 

Access the ModelCenter MBSE connector on the Utilities ribbon. Once you complete the wizard, this will launch and import the data into ModelCenter MBSE allowing you to complete your analysis in ModelCenter MBSE.

 

NOTE:

To learn more about the ModelCenter connector, how to set it up and how to use it, please read the ModelCenter MBSE Connector Guide located in the Documentation folder.